What do welders need to know before striking the arc? Artem Komarov noted that two fundamental principles of aluminum welding: knowing the role of oxygen
Рубрика: Технологии
Комаров Артем об устранении недостатка плавления и пористости при дуговой сварке под флюсом (eng)
Artem Komarov clarified that when welding with full penetration and porosity near the middle of the weld, porosity appears as small or large gas pockets
Артем Комаров об исключении операции постобработки и улучшениях при подготовке к сварке
Artem Komarov explained that to prepare a material edge for welding, fabricators often make bevel cuts on the sheet metal. Beveled edges increase the weld
Комаров Артем о процессе сварки алюминиевых отливок (eng)
Are aluminum castings weldable? Let’s look into this issue, said Komarov Artem. The answer is that most aluminum castings are easy to weld. However, when
Комаров Артем о нормах безопасности на современном промышленном предприятии
Artem Komarov noted that at its most basic, the E-stop circuit is intended to stop all movement on a machine. However, a properly designed E-stop
Комаров Артём о технологических достижениях в многопроцессорных сварочных аппаратах (eng)
Artem Komarov clarified that can a multi-processor welder be useful for an operation that mainly uses one welding process? Yes, thanks to technological advances inherent
Комаров Артём о пористости сварного шва (eng)
Numerous attempts to correct porosity end up worsening the situation, not just leaving it unattended. Usually, complete removal is required, but this can be both
Комаров Артём о дефектах при односторонней дуговой сварке под флюсом (eng)
Komarov Artem noted that single-sided submerged arc welding (SAW-OSW) is a unique process that produces a high-quality overlay that appears to be welded on both
Комаров Артём о влиянии газов на сварочную дугу (eng)
Komarov Artem explained that the most common shielding gas for both processes is CO2 due to its cleansing action and low cost. CO2 is an
Комаров Артём о грунтовке для импульсной сварки (eng)
Artem Komarov explained that in applications requiring high deposition rates, pulse welding reduces heat generation even when using flux cored wire. Since the arc current